Short answer
A light layer of white frost on your heat pump’s outdoor coil is normal in cold, damp weather. The unit clears it with a defrost cycle that usually lasts about 5 to 15 minutes and often sends up a cloud of steam. A unit encased in thick ice, with ice on the top or fan, or frost that never clears, is not normal and needs service. Never chip the ice off.
Normal frost vs. a real problem
| Normal | Not normal: call for service |
|---|---|
| Thin white frost on the coil fins | Thick, clear ice covering the coil like a block |
| Frost that clears every hour or so | Frost or ice that stays for hours and keeps growing |
| Steam rising from the unit for a few minutes | Ice on the top grille, or the fan blades frozen in place |
| A “whoosh” sound and the outdoor fan stopping briefly | Fan not spinning at all while the compressor hums |
| Ice on the unit right after a freezing rain storm that clears within the day | House getting colder and backup heat running constantly |
How the defrost cycle works
In heating mode, the outdoor coil is colder than the outdoor air. That’s how it pulls heat out of a 35°F day. Moisture in the air condenses and freezes on that cold coil, the same way frost forms on a cold drink can.
Frost blocks airflow through the coil, so every heat pump has a defrost control. When it senses frost building, it briefly switches the system into cooling mode. Hot refrigerant runs through the outdoor coil and melts the frost from the inside. During those few minutes you may notice:
- The outdoor fan stops.
- A loud whoosh or click as the reversing valve shifts, then again when it shifts back.
- Steam pouring off the unit. It looks alarming, but it’s just melting frost hitting cold air. It’s not smoke.
- Backup heat (electric strips or your furnace on a dual-fuel system) coming on so you don’t get cool air inside.
How often this happens depends on the weather and the equipment. Some units defrost as often as every 30 to 35 minutes in damp conditions, and others go much longer. Here’s what surprises a lot of people: defrost often runs most when it’s in the 30s and 40s and humid, not on the coldest, driest nights. That’s typical Northern Virginia winter weather.
Why a heat pump ices up
The defrost system isn’t working
A failed defrost control board, a bad coil temperature sensor or a stuck reversing valve means frost builds and never gets cleared. Frost turns into ice, ice turns into a block. It’s one of the most common causes of a frozen heat pump.
Low refrigerant
A refrigerant leak makes the outdoor coil run colder than it should, so it frosts faster than defrost can keep up. Often you’ll also notice the heat pump struggling to keep the house warm. Refrigerant doesn’t get “used up”, so low refrigerant means a leak that needs finding and repairing.
Blocked airflow
Leaves, snow drifts, overgrown shrubs or a cover left on from summer all restrict airflow through the coil. Less airflow means a colder coil and more frost. Keep about two feet clear around the unit and never cover it while it’s in use for heating.
Water dripping on it from above
Check this first if your outdoor unit sits under a roof edge. A gutter that overflows or leaks drips water straight onto the unit, and in freezing weather that water turns into a cap of ice no defrost cycle can melt. Fix the gutter, add a downspout extension, or move the unit.
The unit sits too low
Heat pumps need to drain the water from each defrost. A unit sitting on the ground or a sunken pad can refreeze that meltwater into its base, and a few inches of snow can bury the bottom of the coil. A stand that raises the unit several inches off the ground solves both.
Freezing rain
Northern Virginia gets its share of ice storms. After freezing rain, your heat pump will be coated like everything else in the yard. Give it time. The defrost cycle should start clearing the coil over the next several hours. If the fan is frozen solid or the ice isn’t shrinking by the next day, call.
What to do if your heat pump is frozen
- Don’t chip, scrape or hammer the ice. The coil fins and refrigerant tubes are thin. One slip can puncture a line and turn a service call into a major repair.
- Switch the thermostat to “Emergency Heat” (or “EM Heat” / “Aux Heat”) if it has that setting. This stops the outdoor unit and heats the house with your backup heat while the ice melts. If you have no backup heat setting, turn the system off and use safe space heaters while you wait.
- Clear away snow, leaves and anything blocking the unit by hand. Check for water dripping on it from above.
- Let it thaw. If you need to speed it up, pour warm (not boiling) water over the coil. Don’t use a heat gun, torch or open flame.
- Turn it back to normal heat once the ice is gone and watch it. If ice builds back up within a day, there’s an underlying problem that needs a technician.
Emergency heat is fine for a day or two, but it’s expensive to run because electric strips cost far more per hour than the heat pump does. Don’t leave it on all winter as a workaround.
How to keep it from happening again
- Get a heating-season tune-up. A technician tests the defrost control and sensor, checks refrigerant and cleans the coil. Our maintenance plan covers it.
- Keep the unit raised and the area around it clear.
- Fix gutters and downspouts above or near the unit.
- Change the indoor filter regularly. Restricted indoor airflow makes the whole system work harder (see how often to change your air filter).
Frequently asked questions
Is it normal for a heat pump to have ice on it in winter?
A thin layer of frost is normal, and the defrost cycle clears it regularly. Thick ice covering the coil, ice on the top or fan, or frost that doesn’t clear for hours is not normal and points to a defrost, refrigerant or airflow problem.
Why is steam coming out of my heat pump?
That’s the defrost cycle. The heat pump briefly sends hot refrigerant through the outdoor coil to melt frost, and the meltwater turns to steam in the cold air. It’s normal and usually stops within 5 to 15 minutes.
How long does a heat pump defrost cycle last?
Typically about 5 to 15 minutes, and many cycles are shorter. How often it runs depends on temperature and humidity; damp weather in the 30s and 40s causes more frequent defrosts than cold, dry weather.
Should I pour hot water on a frozen heat pump?
Warm (not boiling) water is a safe way to speed up thawing once the unit is switched to emergency heat or off. Never chip or scrape the ice, and never use a torch or heat gun, since you can damage the coil and refrigerant lines.
Can I run my heat pump if it’s frozen?
Not for long. A heat pump with an iced-over coil can’t move heat and puts heavy strain on the compressor. Switch to emergency heat or turn it off, let the ice melt, and call for service if it freezes again.
Heat pump frozen and the house getting cold?
We repair all major heat pump brands across Northern Virginia and nearby Maryland, 24/7, with no extra charge for after-hours emergency calls. Learn more about our heat pump services, call 703-360-4357, or book online.
Thinking about an upgrade instead? Read do heat pumps work in Northern Virginia winters?
Sources
- Lennox, Defrost cycle on my heat pump
- Lennox, Heat pump frozen
- EnergySage, Do heat pumps work in cold climates?
- InspectAPedia, Heat pump defrost FAQs