Short answer
A replacement gas furnace typically costs $3,800 to $12,000 installed in 2026, with a national average of about $4,800. Northern Virginia labor runs above the Virginia average, so most local quotes land in the middle-to-upper part of that range. The biggest price drivers are efficiency (80% vs. 95%+ AFUE), venting changes, and whether the furnace sits in a basement or an attic.
Typical furnace replacement costs in 2026
| Source | Installed price range | Notes |
|---|---|---|
| Carrier | $3,800–$12,000 | Varies by home size, local labor rates and AFUE rating |
| Angi data (via Filterbuy) | $3,800–$10,000 for gas | National average about $4,800 |
| HVACbase | $3,500–$8,500 for gas | National average about $5,500 |
| HVAC Project Cost (Virginia) | $5,000–$14,500 | Full system replacement statewide; Northern Virginia labor estimated 10–15% above the state average |
Those ranges are wide because “replace the furnace” can mean a two-day swap in an open basement or a week of work that includes new venting, a chimney liner and duct changes. The sections below cover what moves your number.
What’s included in a furnace replacement quote
A complete quote should list every one of these. If one is missing, ask, because that’s usually where the surprise invoice comes from.
- The furnace itself, with brand, model number, AFUE rating and BTU input.
- Labor to remove the old unit and set the new one.
- Venting: reusing the existing metal flue, or new PVC venting for a high-efficiency model.
- Condensate drain or pump (high-efficiency furnaces only).
- Gas connection, new shutoff valve and leak test.
- Transitions and plenum work so the new cabinet mates to your existing ductwork.
- Permit and inspection. Your contractor should pull the county permit. Ask to see it.
- Thermostat, if it’s being replaced.
- Haul-away of the old equipment.
- Warranty terms: parts years, labor years, and whether registration is required.
80% vs. 95%+ AFUE: the decision that moves the price most
AFUE is the share of the gas you pay for that ends up as heat in your house. An 80% furnace sends about a fifth of it up the flue. A 96% furnace sends about 4% out the vent.
The 80% furnace is cheaper to buy, and in a house that already has a metal flue it’s simpler to install. But it’s a short-lived option.
The U.S. Department of Energy has set a 95% AFUE minimum for new non-weatherized gas furnaces starting December 18, 2028. A federal appeals court upheld the rule in late 2025. After that date, new 80% furnaces (the kind installed in most NoVA basements and attics) can no longer be made for sale in the U.S. If you replace in 2026 you can still choose an 80% model, but you’ll be buying technology that’s on its way out.
A high-efficiency (condensing) furnace costs more for three reasons:
- New venting. It vents through PVC pipe out a side wall or the roof, not up the old chimney.
- Condensate. It produces water that has to drain to a floor drain or a condensate pump.
- The water heater. If your gas water heater shared a chimney with the old furnace, it may now be “orphaned” in a flue that’s too big for it alone. That can mean a chimney liner or new venting for the water heater. In older Fairfax and Arlington homes this is often the line item nobody mentioned at the start.
For the full efficiency comparison, read differences between 80% and 90%+ furnaces.
Other things that raise or lower your price
Location of the furnace. A basement install with clear access is the baseline. Attic furnaces, common in some Loudoun townhouses, take more labor, more care, and sometimes a new drain pan and float switch. Tight utility closets slow everything down.
Single-stage, two-stage or variable-speed. A single-stage furnace is either fully on or off. Two-stage and modulating models run at lower output most of the time, which means quieter operation, more even temperatures and fewer drafty blasts, at a higher price. In a two-story NoVA colonial where the upstairs runs hot and the basement runs cold, the upgrade is often worth it.
Correct sizing. Many furnaces installed in the 1980s and 1990s were oversized, and homes have since been tightened up with new windows and insulation. A load calculation (ACCA Manual J) may show you need a smaller furnace than the one you have, which costs less and runs better.
Your air conditioner’s age. The furnace blower moves air for your AC, and the indoor coil sits on top of the furnace. If your AC is 12+ years old, replacing both together usually costs less than doing them two years apart, and the matched system runs more efficiently. It’s also the right time to consider a heat pump instead of a new AC. See do heat pumps work in Northern Virginia winters?
Ductwork and gas piping. Undersized return ducts, damaged duct sections or a gas line that needs upsizing for a bigger burner all add cost. A good contractor checks these before quoting, not after starting.
Repair or replace?
Gas furnaces commonly last 15 to 20 years. Replacement starts making sense when the furnace is past about 15 years and needs an expensive repair (a heat exchanger, inducer motor or control board), when it has needed repairs several winters running, or when a crack in the heat exchanger creates a carbon monoxide risk. That last one isn’t a judgment call. Replace it.
For the math, see our repair-or-replace cost framework. A furnace tune-up each fall catches many of these problems before the first cold night.
How to compare two furnace quotes
- Line up the model numbers. Look up each one’s AFUE, number of stages and blower type. “96% furnace” on two quotes can mean very different equipment.
- Check that both include the same scope. Venting, condensate, water heater venting, permit and haul-away. A low quote that leaves out the chimney liner isn’t actually lower.
- Ask how the size was chosen. “Same as the old one” isn’t a sizing method.
- Compare warranties properly. A 10-year parts warranty with 1 year of labor is very different from 10 and 10.
- Confirm who does the work. In-house employed technicians or subcontractors?
- Check the license. Look up the contractor’s Virginia license class on the DPOR website.
Paying for a new furnace in 2026
The federal 25C tax credit, which covered up to $600 for a high-efficiency gas furnace, ended for equipment placed in service after December 31, 2025. Virginia’s federally funded Home Energy Rebates had not launched as of 2026. Check with Washington Gas and Dominion for any current utility offers at the time you install.
Most homeowners spread the cost with financing. Air 1 offers financing options and runs seasonal special offers, and a maintenance plan protects the new equipment once it’s in.
Frequently asked questions
How much does it cost to replace a furnace in Virginia?
Most gas furnace replacements cost $3,800 to $12,000 installed nationally, with an average near $4,800. Northern Virginia labor rates run 10–15% above the state average, so local quotes usually fall in the middle-to-upper part of that range. High-efficiency furnaces with new venting cost the most.
How long does a furnace replacement take?
A straightforward like-for-like basement replacement usually takes one day. Switching from an 80% to a high-efficiency furnace with new PVC venting, a condensate drain and water heater venting changes can take one to two days. Attic installs and duct modifications add time.
Do I need a permit to replace a furnace in Northern Virginia?
Yes. Replacing a furnace is mechanical and gas work, and counties in Northern Virginia enforce the Virginia building code through permits and inspections. Your contractor should pull the permit and schedule the inspection. Ask to see the permit number.
Can I still buy an 80% efficiency furnace?
Yes, for now. The Department of Energy’s 95% AFUE minimum for new non-weatherized gas furnaces takes effect December 18, 2028. Until then 80% furnaces can still be made and installed, but most homeowners replacing in 2026 should compare the lifetime gas savings of a 95%+ model before choosing.
Should I replace my AC at the same time as my furnace?
If your air conditioner is more than about 12 years old, usually yes. The two share a blower and an indoor coil, and replacing them together typically costs less than two separate jobs and gives you a matched, more efficient system.
Get an exact price for your home
A range is a starting point. Your real number depends on your venting, your furnace location and what your house actually needs. We’ll measure, run the load calculation and give you a written, itemized quote. No pressure, and no after-hours charge for emergencies.
Call 703-360-4357 or book a free estimate. Learn more about our furnace replacement and installation service.
Sources
- Carrier, Gas furnace replacement guide
- Filterbuy (Angi data), Furnace installation cost
- HVACbase, Furnace installation cost
- HVAC Project Cost, HVAC replacement cost in Virginia
- U.S. Department of Energy, Consumer furnace efficiency standards
- ACHR News, Furnace efficiency standard upheld